HPE Community
Operating System - HP-UX
1833729 Members
2713 Online
110063 Solutions
New Discussion

Nodelock license port aggregation software

 
E-Ontap
New Member

‎03-26-2002 10:41 PM

‎03-26-2002 10:41 PM

Nodelock license port aggregation software

I have a server with three lan card. After installing the port aggregation software, the output from the i4target become funny, it will generate a target ID of ff00000.

I cannot use this target ID to apply for license because this is invalid.

The nodelock license is for medusa. I don't know why the i4target keep look for a virtual interface
0 Kudos
Reply
2 REPLIES 2
K.Vijayaragavan.
Respected Contributor

‎03-26-2002 11:22 PM

‎03-26-2002 11:22 PM

Re: Nodelock license port aggregation software

Hi,

"i4target" command used show the mac address of the LAN card in it's second half portion.

Ensure you have the lan card.

Use the comamnd "lanscan" to find the mac address.

"i4target -c " to change the target ID.

-Vijay
"Let us fine tune our knowledge together"
0 Kudos
Reply
E-Ontap
New Member

‎03-26-2002 11:34 PM

‎03-26-2002 11:34 PM

Re: Nodelock license port aggregation software

this is useless also..because when I use i4target -c ...all lan interface show up but all with the same target ID of ff00000
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.