Not able to print using lp thro jetDirect

[yc_2]

Hi,

I installed jetDirect into a newly installed rp3440 running UX11i. New print queue created and tested without problem but not able to print using lp -d command. It does not shown in the request after submitted the lp command.

I followed the following thread but no success:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=567111

Any advice is appreciated.




Thanks in advance,
YC

[Fred Ruffet]

How does printer queue appear in sam ? or in lpstat ?

Regards,

Fred

[yc_2]

Hi,

Output of lpstat -t:

scheduler is running
no system default destination
device for 09_07_001_hp2: /dev/null
09_07_001_hp2 accepting requests since Dec 1 15:51
printer 09_07_001_hp2 is idle. enabled since Dec 1 15:51
fence priority : 0
no entries

[RAC_1]

Shutdown lpsched. Start it. lpsched -v
Fire a print job. check /var/adm/lp/log file.
Also do as follows.

hpnpadmin -v "print_queue"

Hope this helps

Anil

[V. Nyga]

YC,

what's your complete lp command?

Volkmar

[Steve Steel]

Hi


lpshut
lpsched -v

Print 2 things

look in /var/spool/lp/log

then
lpshut
lpsched


Also if you do lp -d 09_07_001_hp2

It will try for the default which you do not have and think the printer 09_07_001_hp2 is a file



Use
/usr/sbin/lpadmin -d09_07_001_hp2

To make it the default

Steve STeel

[Geoff Wild]

What is output of:

lpstat -d


If nothing, then follow Steve's response.

Rgds...Geoff

[yc_2]

Managed to find the solution by comparing the print queue files and directories with other server. The directory /etc/lp/interface/model.orig was set to 700 after jetDirect installed. It should be 755.