Openssh, who command and X11

[Jdamian]

Hi everyone again.

I installed the same OpenSSH depot in two different machines. HP-UX 11.0 runs in both but who -R command reports different format in both systems. In one output from 'who' is:

user ttyp1 2 Dic 18:03 (192.27.44.1:10.0)

in the other is

user ttyp1 2 Dic 18:03 (192.27.44.2)

Note the X11 suffix in the first case.

I use ReflectionX and these outputs are caused by HPterm Xclients. Their releases are the same in both systems (what command reports the same).

If I use a non X client to connect (Reflection for Host and Unix for instance) IP address is right.

/etc/opt/ssh/sshd_config are the same in both systems.

Perhaps sshd is not the cause, but when TELNET protocol is used from ReflectionX is used, both system behave fine and same.

Any ideas ?

[Jerome Fenal_1]

Maybe one, yes :

did you activate in your SSH client X11 forwarding for the connection to the second machine ?

Regards,

J??r??me