output from frecover -rN

[Greta Blamire]

I have been using frecover -rN to check my backup tapes, and it works great on my partial backup of data only. But when I attempt to verify a full system backup it runs for awhile and then just stops, giving no error message. It always stops verifying in the same place, and the rest of the files are demonstratively on the tape, but are not getting verified. Anyone have experience with this?
Thanks in advance!

[Venu_2]

Hi,

>> It always stops verifying in the same
>> place, and the rest of the files are
>> demonstratively on the tape, but are not >> getting verified.

I suspect the area on the disk where these files are. Check for any error during backup and skip these files during backup.

Later run frecover and check.

regards

venu