pb fiber channel and EMS

[Ludovic Derlyn]

Hi,

I have a problem with fiber channel (combo card AB465-60001) and EMC DMX1000
When I disconnect a fiber and reconnect, status is "AWAITING LINK UP"
"Fcmsutil /dev/fcdx reset" reinitialize fiber and status is "ONLINE"
Hp and EMC investigate to this problem ...
Workaround is to check status of fiber and reinitialize if needed.
For check , I use EMS (but two fibers are down in EMS and up for fcmsutil

have you an idea for corrected this ?

regards

L-DERLYN

[Ludovic Derlyn]

Hi,

I have not precised, Power Path is installed on the hosts , and i have verify by powermt display dev=all , all paths are corrects, no paths are dead.

Regards

L-DERLYN

[Ludovic Derlyn]

I have fin, i need to execute set_fixed -n \* for set all to UP