PerfView...

[Sandip Samanta]

Hi All,

Would you pls let me know how to configure PerfView. Actually Measure software has been installed in our N class server. But I did not get any executable PerfView file.

Pls let me know how to configure it..

[Manju Kampli · Accepted solution]

You must be installed with the product Perfview. The perfview product does not come with Measureware. This perfview is a priced product. The executable for perfview is "pv". check your system whether this product has been installed using "swinstall" command. In the application CD you will find a trial version of Perfview which you can use it for 60 days and aftet this the lic will expire and you need the permanent lic to activate this again.

[vselvaraj]

Hi,

As manju said , Perfview is a priced product,
to verify whether perfview is installed or not,use swlist command.If is not there you can install the trial version of perfview
which will be there in your application cds.
'pv' is the executable command to start the
perfview.
before this check your measureware is running
currently on your M/C,
To Check : /opt/perf/bin/mwa status,
if all the processes are not running start
by using the following command.
To Start : /opt/perf/bin/mwa start
Start Perfview by giving command #pv,

Good Luck
Selva...

[Vikas Khator]

Hi,

You just need 1 copy of perfview running on one machine and you can use it to connect to all other machines on your network running MeasureWare.

Saving you a buck with my 2 cents.