HPE Community
Operating System - HP-UX
1833934 Members
1696 Online
110063 Solutions
New Discussion

Re: Perl 5.6.1 and Tk ancd gcc 3.1

 
Donny Jekels
Respected Contributor

‎07-15-2003 12:14 PM

‎07-15-2003 12:14 PM

Perl 5.6.1 and Tk ancd gcc 3.1

Okay, this is where I am and cannot continue.

Does anyone know if there is a Perl/Tk port out there that will compile with my setup?
"Vision, is the art of seeing the invisible"
0 Kudos
Reply
2 REPLIES 2
Ollie R
Respected Contributor

‎07-15-2003 08:30 PM

‎07-15-2003 08:30 PM

Re: Perl 5.6.1 and Tk ancd gcc 3.1

Hi,

You can get all Perl-related stuff from:
http://www.cpan.org

Just have a dig around and you'll find pretty much anything you're looking for!

Ollie.
To err is human but to not award points is unforgivable
0 Kudos
Reply
Donny Jekels
Respected Contributor

‎07-16-2003 04:16 AM

‎07-16-2003 04:16 AM

Re: Perl 5.6.1 and Tk ancd gcc 3.1

Olie, thanks but I've been there.

To get this pTk to compile on HP-UX 11.0, I had to remove gcc 3.1, re-installed gcc3.2, flex and bison.

Now I am happy to say Perl/Tk is compiled, tested and working great.

My next question, is. Does anyone know which directories I can tar up to build a pre-compiled Perl/Tk?
"Vision, is the art of seeing the invisible"
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.