Problem at used Xmanager 2.0 in HPUX 10.20

[Oscar Castillo Murillo]

Message error:

dtsession: The ToolTalk session server (ttsession) could not be started. This
indicates that either ToolTalk is not installed or that it is not
installed correctly on this machine. Please see your System
Administrator.

[RAC_1]

1) From the CDE login select Options -> Session -> Failsafe Session
and login as root.
2) Run /usr/contrib/bin/X11/dr_dt. The end of the output from this
script says: X ERRORs and X WARNINGs. These errors and warnings
should be resolved before CDE will run properly.
3) Check the error log /var/dt/Xerrors
Check the error log $HOME/.dt/errorlog
4) The output from "nslookup " and "nslookup " should
be the same. This checks for a) duplicate IP addresses or
hostnames or b) problems with name resolution. If nslookup fails
then CDE will fail to start. If the first line returned from nslookup
is: "Name Server" then you are using DNS. Move "/etc/resolv.conf" to
another name, i.e. /etc/resolv.conf.orig and then try logging into CDE again. if it works there's a problem wrt name resolution.
5) Check permissions and ownership of the following files:
-r--r--r-- 1 bin bin 616 Jul 1 16:03 /etc/hosts
-r--r--r-- 1 root sys 1010 Jun 25 18:22 /var/adm/inetd.sec
6) Check the contents of /var/adm/inetd.sec. It should contain
dtspc allow
spc allow
mserve allow
If not add the lines and run "/usr/sbin/inetd -c" to reread the file.
7) /usr/sbin/ping
You should get back 0% packet loss. If you get something different
then check your network configuration.
8) Make sure the $LANG environment variable is set correctly. It should
be set to C or unset for American-English.
9) Exit the failsafe session. From the CDE login select Options ->
Command Line Login. When the screen turns black, press and
you should get a Console Login prompt. Login as root.