Operating System - HP-UX
1834178 Members
2306 Online
110064 Solutions
New Discussion

Problem in setting-up an external modem on a K260 server using the UPS port

 
SOLVED
Go to solution
Rui Vilao
Regular Advisor

Problem in setting-up an external modem on a K260 server using the UPS port

Greetings,

I am trying to set-up modem for dial-out on a K260 server using the UPS port.

# ioscan -fnkCtty
Class I H/W Path Driver S/W State H/W Type Description
============================================================
tty 0 10/4/0 mux2 CLAIMED INTERFACE MUX
/dev/diag/mux0 /dev/diag/tty0p7 /dev/tty0p1
/dev/diag/tty0p0 /dev/mux0 /dev/tty0p7
/dev/diag/tty0p1 /dev/tty0p0

As far as I understand, the UPS 9 pin serial port device file is /dev/tty0p1

I have entered the following entry to /etc/uucp/Devices:
Direct tty0p1 - 9600 direct

When I enter "at" I do not get OK:

# cu -l tty0p1
Connected
at

I have tried the same procedure on a D230 server using the serial 2 port and
it worked... May be the HW connections are different on the K260?

Thanks in advance for your help,

Kind Regards,

Rui.
"We should never stop learning"_________ rui.vilao@rocketmail.com
2 REPLIES 2
Devbinder Singh Marway
Valued Contributor
Solution

Re: Problem in setting-up an external modem on a K260 server using the UPS port

Hi,
This has been discussed before , ( select search and modems in the forums) , from what i remember, the UPs has different pinouts from a normal serial port , so you cannot use the standard modem cable .
Seek and you shall find
Rui Vilao
Regular Advisor

Re: Problem in setting-up an external modem on a K260 server using the UPS port

Thanks for your contribution Devbinder Singh Marway.

I made a search but I did not find a similar discussion...

Does anyone know the required pinout configuration so
I can make a cable...

Thanks,

Rui.
"We should never stop learning"_________ rui.vilao@rocketmail.com