problem with ems monitor that is delete

[Ela]

Hi

i m working with hp-ux 11.11 with service guard with 3 nodes .

i m defining my monitors in the EMS with the SAM .
whe i m rebooting my system every thing is o.k but when one of my system TOC , after the reboot i can see that all the define of the cluster that i m doing with the SAM are deleted .

i have all EMS and STM patches install on my system ,
any ideas ???????

[RolandH]

See this warning message if you configure the EMS service with the terminal UI (/etc/opt/resmon/lbin/monconfig)


if you have used the Event Monitoring Service (EMS) Graphical
User Interface (GUI) within the System Administration Manager (SAM) to
configure the event monitors, this configuration will not be saved, and no
actual monitoring will take place until hardware event monitoring is
re-enabled and you add the monitoring requests back again using the EMS
GUI. Event monitoring resources show up in the EMS GUI under the resource
class "status".


HTH
Roland

[Ela]

Hi

i didnt see at any referance that when you are config. with the GUI that changes are not save .

i know about the monconfig but i have never use it to define my monitor .

also the issue that it is delete only on TOC and not a normal reboot is also an issue that i dont know why is happening .

so i dont think it is the issue that i m defining it with the SAM ( i also check the version of SAM patch , i have the last patch install )

[Ela]

i can see that it happening in all server that i have

[Ela]

di anybody have any more idea on this issue ?

[RolandH · Accepted solution]

What version of MCSG do you using?

Read this note. There is a compatibility problem with some MCSG Versions.

-->http://www4.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000069098997#problems

Roland

[Ela]

Hi

thanks , the doc was good , i m using S.G 11.14

[RolandH]

And read this Online Document for your installed Release. There are patches that are needed before the product is installed.

Roland

http://docs.hp.com/hpux/onlinedocs/diag/st/st_read.htm

[Hemanth Gurunath Basrur]

Hi Ela,

Please refer to Compatibility Information and Installation Requirements section in the EMS Event Monitoring Service Version A.04.00 Release Notes

http://docs.hp.com/hpux/onlinedocs/B7609-90020/B7609-90020.html

Also, refer to High Availability Monitors Version A.04.00 Release Notes

http://docs.hp.com/hpux/onlinedocs/B5736-90044/B5736-90044.html

Hope this helps.

Regards,
Hemanth