HPE GreenLake Administration
- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - HP-UX
- >
- PS2 timeout on 10.2 boot (w/ KVM switch)
Operating System - HP-UX
1830898
Members
2892
Online
110017
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-02-2003 08:31 AM
06-02-2003 08:31 AM
PS2 timeout on 10.2 boot (w/ KVM switch)
Hi all,
On booting 10.2 (with a KVM switch installed), an error message is shown (something to the effect of):
PS2 timeout - no response after 500usec
It may simply be a hardware incompatibility (for which an increase in the time will not matter at ALL), but otherwise wondered if this timeout value can be set in some config file *somewhere*.
Thanks in advance!
On booting 10.2 (with a KVM switch installed), an error message is shown (something to the effect of):
PS2 timeout - no response after 500usec
It may simply be a hardware incompatibility (for which an increase in the time will not matter at ALL), but otherwise wondered if this timeout value can be set in some config file *somewhere*.
Thanks in advance!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
Company
Events and news
Customer resources
© Copyright 2025 Hewlett Packard Enterprise Development LP