HPE Community
Operating System - HP-UX
1847247 Members
2967 Online
110263 Solutions
New Discussion

Re: Pvlink status error

 
Alice Seeley
Frequent Advisor

‎04-19-2006 04:12 AM

‎04-19-2006 04:12 AM

Pvlink status error

I have a customer who has pvlinks set up and is getting a critical error (HPUX OS /vg/vg02/pv_pvlink/status/c68t4d2 EMS Problem Event: Value: "DOWN(3)" For Resource: "/vg/vg02/pv_pvlink/status/c68t4d2" (Threshold: != UP) yet when he looks at the syslog there are no issues. Ioscan shows everything is good.
0 Kudos
Reply
3 REPLIES 3
Kent Ostby
Honored Contributor

‎04-19-2006 06:12 AM

‎04-19-2006 06:12 AM

Re: Pvlink status error

This was a known problem with EMS that was fixed initially in the following patches:

[PHSS_28144/PACHRDME/English] for HPUX 11.0
[PHSS_28145/PACHRDME/English] for HPUX 11.11
"Well, actually, she is a rocket scientist" -- Steve Martin in "Roxanne"
0 Kudos
Reply
Alice Seeley
Frequent Advisor

‎04-20-2006 01:39 AM

‎04-20-2006 01:39 AM

Re: Pvlink status error

thanks for the quick response. I have checked on the system and and that patch was superceded by PHSS_28844 and that is applied on the system. Anyone have any other suggestions?
0 Kudos
Reply
Prashant Zanwar_4
Respected Contributor

‎04-20-2006 05:59 AM

‎04-20-2006 05:59 AM

Re: Pvlink status error

you said ioscan shows all good..
Is there any time stamp associated in EMS?
And if you can check diskinfo, you should be all good..
Check if EMS is repeating these messages..
might be time to reset your fibre..

Thanks and regards
Prashant
"Intellect distinguishes between the possible and the impossible; reason distinguishes between the sensible and the senseless. Even the possible can be senseless."
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.