HPE Community
Operating System - HP-UX
1834650 Members
2278 Online
110069 Solutions
New Discussion

Re: "autopath retrieve" not working

 
Hanry Zhou
Super Advisor

‎05-07-2008 07:25 AM

‎05-07-2008 07:25 AM

"autopath retrieve" not working

I just upgraded securepath to sp3, but getting error when I run this command:
autopath retrieve

AUTOPATH : persistence file not found or corrupted. Command cannot proceed

It seems the persistence file is missing. Would that be an issue? how to re-create the file, and then make the command working?
none
0 Kudos
Reply
1 REPLY 1
Steven E. Protter
Exalted Contributor

‎05-07-2008 07:51 AM

‎05-07-2008 07:51 AM

Re: "autopath retrieve" not working

Shalom,

IF this file was there before the upgrade, it was most likely removed by a bug in the upgrade process.

You may be right that re-creating the file will solve the problem, but you should also check for new patches, because this could be evidence of a new bug or incomplete installation of securepath.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.