HPE Community
Operating System - HP-UX
1835360 Members
3685 Online
110078 Solutions
New Discussion

"Failed to patch new partition's kernel" in virtual partition

 
Chotiwit Jiratrakarnkit
Occasional Contributor

‎05-07-2008 09:11 AM

‎05-07-2008 09:11 AM

"Failed to patch new partition's kernel" in virtual partition

I've installed virtual partition and boot to vpmon.
After i try to vparload vpar1 i found this message.

MON> vparload -p vpar1
[MON] Booting vpar1...
MON> [vpar1]
Failed to patch new partition's kernel

[MON]
[MON] vpar1 has halted.

what's wrong with my system.
Please help.
1 person had this problem.
0 Kudos
Reply
4 REPLIES 4
Torsten.
Acclaimed Contributor

‎05-07-2008 10:22 AM

‎05-07-2008 10:22 AM

Re: "Failed to patch new partition's kernel" in virtual partition

Did your vpar1 ever run before?

If not, how did you install the OS on it?

What was the last action taken before this attempt to boot?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Chotiwit Jiratrakarnkit
Occasional Contributor

‎05-07-2008 07:30 PM

‎05-07-2008 07:30 PM

Re: "Failed to patch new partition's kernel" in virtual partition

vpar1 I've generated cpu::2,mem::512,io::0/0/2,io::0/0/2/0.0.0:boot

By boot disk is 0/0/2/0.0.0 [same as default boot disk] because i want use running O/S in vpar1
0 Kudos
Reply
Safarali
Valued Contributor

‎05-07-2008 08:52 PM

‎05-07-2008 08:52 PM

Re: "Failed to patch new partition's kernel" in virtual partition

Hi
Apply this command

vparboot -p hostname -I

Please let me know the result

Regards
Safar
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎05-07-2008 09:16 PM

‎05-07-2008 09:16 PM

Re: "Failed to patch new partition's kernel" in virtual partition

Safar, why booting from ignite?

And why should this command work if he has the MON> prompt only?


Please boot again in non-vpar mode and check your config again (swverify for the software, vparstatus for the config).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.