rpc message in syslog.log

[Claus Mordhorst]

Hi all,
since I have upgrade my compute servers (four J6700) to 11.i, I got an error message from rpcbind in the syslog file:

rpcbind: cannot accept connection: bad call sequence number (current state 4)

Does anyone know about that ???

Thx.
Claus

[Ravi_8]

Hi Claus

These error messages are common upon Upgrade, so most of the people prefer cold install.

try by installing recent GOLGQPK11i(support plus CD) patch bundle.

[Dietmar Konermann]

Hi, Claus!

You should try to install the current STREAMS cumulative patch PHNE_27703.

Best regards...
Dietmar.

[T G Manikandan]

hp doc

http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000065774433

[Ricardo Bassoi]

Claus,

#Check the /etc/rpc file if it??s ok, so exit, if not, change the lines and save.

After the above changes or not do a restart
#inetd -c

To see whether RPC service is running use this command
#rpcinfo

more details
#man rpcinfo


Regards,

Ricardo

[Claus Mordhorst]

Hi,
whoa very fast response here ;-).

@ravi,
sorry I forgote to say that it was a installation from scratch. I installed from a 11.i ignite depot.

@Dietmar
I'll try this patch PHNE_27703

thx.
claus

[Ricardo Bassoi]

Hi Claus,

Asign points is a good pratice in the Forums.

Regards,

Ricardo Bassoi

[Claus Mordhorst]

Hi All,
now I have check all the rpc settings and found nothing special.
Moreover I have talk to ohter admins in my company and found out that the patch, Dietmar mentioned is not an option for me, because of company standard Unix environment within philips !

So I have to give up and tell the UNIX standardisation group about my problem.

Thanks a lot to all.

Regards.
Claus

[Dietmar Konermann]

Claus, pointing to the Streams patch was not only a guess. If you really hit JAGad98794 then then PHNE_27703 is the fix for your problem.