HPE Community
Operating System - HP-UX
1833172 Members
3504 Online
110051 Solutions
New Discussion

Run Script-Ignite in mode Single Maintenance

 
Gino Valdés
Occasional Contributor

‎07-05-2000 03:03 PM

‎07-05-2000 03:03 PM

Run Script-Ignite in mode Single Maintenance

I want to make scripts to take advantage of the functionalities Software Ignite-UX so that these can be executed by operators in monousuary way (single user).

0 Kudos
Reply
3 REPLIES 3
Patrick Wessel
Honored Contributor

‎07-06-2000 03:02 AM

‎07-06-2000 03:02 AM

Re: Run Script-Ignite in mode Single Maintenance

I'm not sure if this is all, but you need at least the following steps:

a. mount /usr #maybe you need a fsck
b. mount /var
c. mount /opt
d. /sbin/init.d/hostname start #set hostname
e. /sbin/init.d/net.init start #configure loopback interface (hp-ux 11.X only)
f. /sbin/init.d/net start #configure LAN interface
g. /sbin/init.d/diagnostic start #start des diagnostic daemon
h. /sbin/init.d/swagentd start #start the swagentd

give it a try and report your results, please
There is no good troubleshooting with bad data
0 Kudos
Reply
Patrick Wessel
Honored Contributor

‎07-06-2000 03:07 AM

‎07-06-2000 03:07 AM

Re: Run Script-Ignite in mode Single Maintenance

forget about point g. no idea why you should start the diagnostics daemon!
There is no good troubleshooting with bad data
0 Kudos
Reply
CHRIS_ANORUO
Honored Contributor

‎07-06-2000 04:28 AM

‎07-06-2000 04:28 AM

Re: Run Script-Ignite in mode Single Maintenance

You have to mount /tmp and also start /sbin/init.d/inetd.
When We Seek To Discover The Best In Others, We Somehow Bring Out The Best In Ourselves.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.