HPE Community
Operating System - HP-UX
1847874 Members
4096 Online
104021 Solutions
New Discussion

rx7640 sanboot vpar

 
kholikt
Super Advisor

‎04-09-2007 03:36 PM

‎04-09-2007 03:36 PM

rx7640 sanboot vpar

Hi,

I have one rx7640 and we are going to use vpar to partition the rx7640. I would like to connect the rx7640 and sanboot from EMC storage. Is this possible in the vpar environment?
abc
0 Kudos
Reply
3 REPLIES 3
Torsten.
Acclaimed Contributor

‎04-09-2007 06:58 PM

‎04-09-2007 06:58 PM

Re: rx7640 sanboot vpar

Hi,

iz is possible if your array is supported as a HP-UX boot device.
To confirm see
http://www.hp.com/products1/serverconnectivity/mass_storage_devices.html

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
kholikt
Super Advisor

‎04-09-2007 07:24 PM

‎04-09-2007 07:24 PM

Re: rx7640 sanboot vpar

any link to the documentation on how vpar work.
abc
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎04-09-2007 07:29 PM

‎04-09-2007 07:29 PM

Re: rx7640 sanboot vpar

http://docs.hp.com/en/oshpux11iv2.html#Virtual%20Partitions

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.