HPE Community
Operating System - HP-UX
1833832 Members
2201 Online
110063 Solutions
New Discussion

Re: Sam/ Automated backup fails

 
pb raju
Occasional Contributor

‎10-02-2005 06:39 PM

‎10-02-2005 06:39 PM

Sam/ Automated backup fails


Hi ,
SAM/Automated backup/fbackup to tape drive C6362A fails with error message :"ANSII standard label not yet implementedFBACKUP_LABEL".
The tape drive is new.(Hp-ux version B.11.11)

If I run fbackup manually with the command
fbackup -f /dev/rmt/0m -u0g graph -I index.full,
it works.

What can be reason for the backup failure ?

Regards
Raju

0 Kudos
Reply
2 REPLIES 2
Muthukumar_5
Honored Contributor

‎10-02-2005 06:43 PM

‎10-02-2005 06:43 PM

Re: Sam/ Automated backup fails

You have to lable a tape when you are trying with sam backup. fbackup will lable it however sam won't.

check this:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=738089

hth.
Easy to suggest when don't know about the problem!
0 Kudos
Reply
Arunvijai_4
Honored Contributor

‎10-02-2005 07:01 PM

‎10-02-2005 07:01 PM

Re: Sam/ Automated backup fails

Take a look at these threads,

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=762604
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=847515
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=846218

-Arun
"A ship in the harbor is safe, but that is not what ships are built for"
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.