Operating System - HP-UX
1833851 Members
2584 Online
110063 Solutions
New Discussion

SAM is not seeing the second Tachyon Adapter but ioscan does

 
Kevin Keller_2
Frequent Advisor

SAM is not seeing the second Tachyon Adapter but ioscan does

I'm running an N4000 with two Tachyon adapter card, connected to a VA7400 running 11i. If I run ioscan I can see both adapters and the array. When I run SAM I only see one of the adapters and only the portion of the array it's attached to. How can I fix this? The patch levels are up to date. Thank you.
1 REPLY 1
George Neill
Trusted Contributor

Re: SAM is not seeing the second Tachyon Adapter but ioscan does

Question about the second Tachyon. Is it an alternate path to the same disks as seen from the first Tachyon? If so 11i may not show the alternate path to a disk. 11.0 and earlier always showed all visible paths.