sh: make_tape_recovery: not found.

[Rowan Cabato]

please HELP...

Every time i run this command
# make_tape_recovery -Av
this error always display.
sh: make_tape_recovery: not found.

tried reinstallaing Ignite. but encountered some errors

ignite version c7.7.98.

below is the error message

======= 05/26/09 16:12:04 EAT BEGIN install AGENT SESSION (pid=4295)

* Agent session started for user "root@CRMHPPRODETL01".
(pid=4295)

* Beginning Analysis Phase.
* Source:
CRMHPPRODETL01:/tmp/Ignite-UX-11-23_C.7.7.98_HP-UX_B.11.00_32_64.depot

* Target: CRMHPPRODETL01:/
* Target logfile: CRMHPPRODETL01:/var/adm/sw/swagent.log
* Reading source for product information.
* Reading source for file information.
* Executing preDSA command.
NOTE: The used disk space on filesystem "/" is estimated to increase
by 8 Kbytes.
This will leave 3846592 Kbytes of available user disk space
after the installation.
NOTE: The used disk space on filesystem "/opt" is estimated to
increase by 291552 Kbytes.
This will leave 12138096 Kbytes of available user disk space
after the installation.
NOTE: The used disk space on filesystem "/var" is estimated to
decrease by 48 Kbytes.
This will leave 5739112 Kbytes of available user disk space
after the installation.
NOTE: The used disk space on filesystem "/usr" is estimated to
increase by 80 Kbytes.
This will leave 7818376 Kbytes of available user disk space
after the installation.
NOTE: The bundle "IGNITE,r=C.7.7.98" is already installed. If you
wish to reinstall this bundle, change the "reinstall" option
to "true".
NOTE: The bundle "Ignite-UX-11-23,r=C.7.7.98" is already installed.
If you wish to reinstall this bundle, change the "reinstall"
option to "true".

* Summary of Analysis Phase:
* 17 of 17 filesets had no Errors or Warnings.
* The Analysis Phase succeeded.


* Beginning the Install Execution Phase.
* Filesets: 17
* Files: 530
* Kbytes: 289359
* Installing fileset "Ignite-UX.BOOT-COMMON-IA,r=C.7.7.98" (1 of
17).
ERROR: The internal uncompress routine has detected corruption while
decompressing to file "/opt/ignite/boot/fpswa.efi" which has
compression type "gzip".
ERROR: tar: /tmp/Ignite-UX-11-23_C.7.7.98_HP-UX_B.11.00_32_64.depot :
This doesn't look like a tar archive
ERROR: tar: /tmp/Ignite-UX-11-23_C.7.7.98_HP-UX_B.11.00_32_64.depot :
Skipping to next file...
ERROR: The file "/opt/ignite/boot/hpux.efi" was not loaded because it
is missing from the source media.
ERROR: The file "/opt/ignite/boot/nbp.efi" was not loaded because it
is missing from the source media.
ERROR: Failed installing fileset
"Ignite-UX.BOOT-COMMON-IA,r=C.7.7.98". Check the above output
for details.
* Retry number 1 of 1 for loading files for fileset
"Ignite-UX.BOOT-COMMON-IA,r=C.7.7.98".
* Installing fileset "Ignite-UX.BOOT-COMMON-IA,r=C.7.7.98" (1 of
17).
ERROR: tar: /tmp/Ignite-UX-11-23_C.7.7.98_HP-UX_B.11.00_32_64.depot :
This doesn't look like a tar archive
ERROR: tar: /tmp/Ignite-UX-11-23_C.7.7.98_HP-UX_B.11.00_32_64.depot :
Skipping to next file...
ERROR: The file "/opt/ignite/boot/hpux.efi" was not loaded because it
is missing from the source media.
ERROR: The file "/opt/ignite/boot/nbp.efi" was not loaded because it
is missing from the source media.
ERROR: Failed installing fileset
"Ignite-UX.BOOT-COMMON-IA,r=C.7.7.98". Check the above output
for details.
NOTE: The Install Phase has suspended. Check the above output for
reasons.

any ideas...what happen.? thanks

[smatador]

Hi,
With this sort of error, I will suspect a corrupted depot. Try to download the depot another time and swverify it.
A thread about this
http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1174645
Hope it helps

[Sunny123_1]

Hi

Check your depot is proper or not

swverify \*

then

swconfigure \*

or try below depot

http://software.hp.com/portal/swdepot/displayProductInfo.do?productNumber=IGNITEUXB

and then install it again.

Regards
Sunny

[Rowan Cabato]

tnx smatador.

one problem is ignite version c7.7.98 is not available anymore. ignite version c7.8.201 is the latest version. just incase i need to recover from cd..i would might a problem.

...any other option...? thanks

[Suraj K Sankari]

Hi,
Give the absolute path like

/opt/ignite/bin/make_tape_recovery

Suraj

[Rowan Cabato]

thanks sunny123

already tried that one. am not sure if i can use the new version if ill recover frrom cd.

thanks Suraj.

ive already tried that one.

[Dennis Handly]

>ignite version c7.8.201 is the latest version. just in case I need to recover from cd.

You can always create a new CD with your latest ignite, so it matches.

One of your messages says: C.7.7.98" is already installed.

Why are you reinstalling it? As Suraj said, does the absolute path exist? /opt/ignite/bin/make_tape_recovery

[Michal Kapalka (mikap)]

Hi,

you could boot directly from the TAPE,

mikap

[Rowan Cabato]

thanks Dennis Handly

yup..ignite is already installed but i keep on encountering the error. thats why i tried reinstalling it.

i tried the command
# /opt/ignite/bin/make_tape_recovery -Av
but the error is still the same.
sh: /opt/ignite/bin/make_tape_recovery: not found.

[OldSchool]

"/opt/ignite/bin/make_tape_recovery not found"

either the original installation had issues, or there is some kind of permissions problem.

what, if anything, is in /opt/ignite/bin ???

[avizen9]

Hello there may be corruption you should try first this

swverify \*

if there is no curruption then

try
which make_tape_recovery

go to path and run it through ./make_tape_recovery

if you still have error better un-install and install it again, thanks,

[Dennis Handly]

>but the error is still the same.
sh: /opt/ignite/bin/make_tape_recovery: not found.

And you have checked and that file isn't there?

>avizen9: there may be corruption you should try first this: swverify \*

Good suggestion.

>if you still have error better un-install and install it again

Right.

[SUDHAKAR_18]

swlist -l fileset -a state |grep -v -e "#" -e "configured"

and

cd /opt/ignite/bin
./make_tape_recovery

please try this...

[Taifur]

Hi,

You have to install IGNITEUX for make_tape_recovery. If previous installed IGNITEUX not work , then remove and install new IGNITEUX.

Then check that issue by make_tape_recovery.

Rgds//
Taifur