shutdown rp4440

[leninvilla]

We needed to know if to use the command shutdown - hy 0 in a rp4440, it must to halt the system or it is due to be made manually.

In the console it shows the following:


from console

- - - - - - - - - - Prior Console Output - - - - - - - - - -
Firmware Version 44.21

Duplex Console IO Dependent Code (IODC) revision 1



System has halted
OK to turn off power or reset system
UNLESS "WAIT for UPS to turn off power" message was printed above

- - - - - - - - - - - - Live Console - - - - - - - - - - - -





from the vfp it shows the following thing:

from vfp


System state Activity # of logs since boot
--------------- -------- --------------------
OS booting or Running 1575



E indicates error since last boot




LEDs | LOCATOR | SYSTEM | POWER
-----------------------------------------------------------------------------
| OFF | ON GREEN | ON GREEN
-----------------------------------------------------------------------------
Status | System running normally.
-----------------------------------------------------------------------------


our question is if in fact the operating system is halted or running.

[Patrick Wallek · Accepted solution]

At this point the OS has been shut down. If you need to power the system off, you must do this from MP or press the power button.

[Torsten.]

Hi,

if you see this message

System has halted
OK to turn off power or reset system
UNLESS "WAIT for UPS to turn off power" message was printed above

The system is halted, until you power cycle or reset it.

[spex]

Hello,


"System has halted; OK to turn off power or reset system" means the system has halted, and it's OK to turn off the power or reset the system.

PCS

[leninvilla]

Hi.



thanks for your responses, they helped so much.


thanks