HPE Community
Operating System - HP-UX
1847180 Members
3323 Online
110263 Solutions
New Discussion

ST373207LW disk installation

 
Mersin
New Member

‎04-03-2007 03:04 AM

‎04-03-2007 03:04 AM

ST373207LW disk installation

Hi,
I bougt a new ST373207LW SCSI disk to my ML 330 G3 server and srever can not identify it.
So i tried to change cable slots ant i tried all cable slots even on working disk. It does not appear in scsi check screen.
What can i do even more. should i try to configure jumper settings?

Regards...
0 Kudos
2 REPLIES 2
Steven E. Protter
Exalted Contributor

‎04-03-2007 05:29 AM

‎04-03-2007 05:29 AM

Re: ST373207LW disk installation

Shalom,

Possibilities:
1) Disk is simply dead. Listen to it or feel it for vibration and see if its spinning up.
2) It is quite possible the disk is conflicting with other disks in the system or the SCSI card, Check that the SCSI ID is not zero the default for controllers.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Mersin
New Member

‎04-04-2007 10:06 AM

‎04-04-2007 10:06 AM

Re: ST373207LW disk installation

Hi,
Thanks for your reply. I checked my disk and you are right. it is not vibrating!
I will see the manufacturer :)

Thanks again.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.