swapinfo information

[Deepak Kulkarni]

Hi All,

When I run swapinfo -M on my hp-ux 10.20 system it wont show the memory usage. Please tell me what may be the reason? Please find the attached document which is the output of the commands.

Thanks to all
Deepak Kulkarni

[Pete Randall]

That would be because you have no pseudo-swap. If you did, your original swapinfo would look like this (note the "memory" line):

# swapinfo
Mb Mb Mb PCT START/ Mb
TYPE AVAIL USED FREE USED LIMIT RESERVE PRI NAME
dev 2048 29 2019 1% 0 - 1 /dev/vg00/lvol2
reserve - 362 -362
memory 729 497 232 68%
total 2777 888 1889 32% - 0 -


Your kernel obviously has pseudo-swap turned off.


Pete

[Nobody's Hero]

try lowercase 'm'. Uppercase just shows paging.

So use, swapinfo -tm

[Deepak Kulkarni]

Hi pete,

Is it swapme_on which you are talking about?


Thanks
Deepak Kulkarni

[Trond Haugen · Accepted solution]

My memory is a bit rusty with regards to 10.20 as it has been out of support for some time now. But are you sure you have pseudoswap configured? (swapmem_on 1 in the kernel)

Regards,
Trond

[Deepak Kulkarni]

Hi pete & trond


My problem got solved in 10 minutes. :-)

cheers
D K

[Deepak Kulkarni]

Hi Robert

Thank you for your response

cheers
D K

[Deepak Kulkarni]

Obviously best forum in the world