to recover vm using ignite tape

[himacs]

Hi Admins,

HPUX 11.31

VSP 6.10.05

I have taken ignite tape backup of a HPUX VM1.The tape drive been assigned from netbackup.

Now i want to recover the VM using ignite tape.But EFI shell not showing any tape drive details.Please find the given vm details.

TEST:/#hpvmstatus -p 4
[Virtual Machine Details]
Virtual Machine Name VM #  Type OS Type State
==================== ===== ==== ======= ========
TEST           4 SH   HPUX    On (OS)

[Runnable Status Details]
Runnable status         : Runnable

[Remote Console]
Remote Console not configured

[Authorized Administrators]
Oper Groups             :
Admin Groups            :
Oper Users              :
Admin Users             :

[Virtual CPU Details]
#vCPUs Ent Min Ent Max
====== ======= =======
     3   10.0%  100.0%

[Memory Details]
Total    Reserved  Overhead
Memory   Memory    Memory
=======  ========  ========
  13 GB     64 MB    192 MB

[Dynamic Memory Information]
Minimum     Target      Memory      Maximum
Memory      Memory      Entitlement Memory
=========== =========== =========== ===========
   512 MB    13306 MB          -     13312 MB

[Storage Interface Details]
vPar/VM                                Physical
Device  Adapter    Bus Dev Ftn Tgt Lun Storage   Device
======= ========== === === === === === ========= =========================
hba     avio_stor    0   1             npiv      /dev/fcd1-0x2001438021DC0B7A,0x2001438021DC0B7B
hba     avio_stor    0   2             npiv      /dev/fcd2-0x2001438021DC0A48,0x2001438021DC0A49
[Network Interface Details]
Interface Adaptor    Name/Num              PortNum Bus Dev Ftn Mac Address
========= ========== ===================== ======= === === === =================
vswitch   avio_lan   test_sw1         1         0   0   0 f2-5a-b8-4b-fa-52

[Direct I/O Interface Details]
vPar/VM                                       Physical
Device  Adapter Bus Dev Ftn Mac Address       Storage   Device
======= ======= === === === ================= ========= ===========

[Misc Interface Details]
vPar/VM                                Physical
Device  Adapter    Bus Dev Ftn Tgt Lun Storage   Device
======= ========== === === === === === ========= =========================
serial  com1                           tty       console

Please let me know how i can proceed.VM is up and working fine. Just i want to test the tape recovering.

Regards

himacs

[Stan_M]

Hi.

HPVM EFI by default enumerates only boot devices (those listed in boot menu).

To change that you need to use drvcfg in EFI. See HPVM V6.1.5 admin guide chapter 11.12.

HTH

Stan

[himacs]

Hi STan,

Thanks for the response. I have doen as per given in doc. But nothing happens.Please find the attached screenshot.

Regards

himacs

[Stan_M]

I'm not sure whether map -r is sufficient to trigger a rescan. Restart the guest.

[Eric SAUBIGNAC]

Oups, a bit late : use reconnect -r after drvcfg and before map