HPE Community
Operating System - HP-UX
1849474 Members
6095 Online
104044 Solutions
New Discussion

Token Ring replies blank station address

 
SOLVED
Go to solution
Francois Boucher_1
Occasional Contributor

‎08-23-2000 01:16 PM

‎08-23-2000 01:16 PM

Token Ring replies blank station address

Hi, I can't install an EISA Token Ring card in a HP Telepace (HP9000/S700 748i) because the card replies a blank station address (using lanscan). The OS is HP-UX 10.20. I installed the HP Software Package J2165A and the PHNE_8337 patch. The card is recognized by eisa_config, but the station address is always blank. The HP 748i is a Workstation with both VME and EISA slots. There are 4 EISA slots. I'm using slot 4.

Any ideas?

Francois Boucher
0 Kudos
Reply
2 REPLIES 2
melvyn burnard
Honored Contributor

‎08-23-2000 11:09 PM

‎08-23-2000 11:09 PM

Solution

Re: Token Ring replies blank station address

I have seen this before when the TR card does not have it's speed set.
try running the eisa_config and setting the card speed first, then check the MAC address.
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!
Reply
Berlene Herren
Honored Contributor

‎08-24-2000 01:19 PM

‎08-24-2000 01:19 PM

Re: Token Ring replies blank station address

This was fixed by applying PHNE_21217.
Had a call just like it earlier this month :)

Berlene
http://www.mindspring.com/~bkherren/dobes/index.htm
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.