HPE Community
Operating System - HP-UX
1834532 Members
3490 Online
110069 Solutions
New Discussion

Re: tsm menu question

 
BFA6
Respected Contributor

‎12-05-2001 12:50 AM

‎12-05-2001 12:50 AM

tsm menu question

Hi,
I've got 2 boxes, A & B. When I remsh from a to b and run an application everything is fine.

If on B I access a tsm menu, and through the menus remsh to B, the application on B gets control codes printed on screen e.g. \E[;36f

Any ideas why this is happening.

Thanks in advance

Hilary
0 Kudos
Reply
2 REPLIES 2
Bill McNAMARA_1
Honored Contributor

‎12-05-2001 02:09 AM

‎12-05-2001 02:09 AM

Re: tsm menu question

type
# env
# stty
# echo $TERM

to check env variables.

You may have a .profile difference on the 2 systems

Later,
Bill
It works for me (tm)
0 Kudos
Reply
BFA6
Respected Contributor

‎12-05-2001 06:16 AM

‎12-05-2001 06:16 AM

Re: tsm menu question

Bill,

env, stty and $TERM are all the same. Would anything be set by tsm that could be causing the problem ?

Hilary
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.