Unable to login after 32-64 bit conversion

[David Lewis_1]

Please help
I have been attempting to convert the O/S from 32 bit to 64 bit and have encountered a few problems. I beleive I have the answer to these however since rebooting the box I am unable to login. I don't even get prompted for a passwd. I have booted the box to single user mode and checked the syslog and I get the following error messages.
load modules: can not open module
/usr/lib/security/libunix.1
pam_sm_acct_mgmt()missing
The file lib.unix.1 exists with 666 permissions
Any ideas why I can't login
Thanks in advance

[Robert-Jan Goossens]

Hi,

is this a trusted system 11.0 or 11.i ?

Robert-Jan

[David Lewis_1]

Trusted 11.00

[Robert-Jan Goossens]

Hi David,

Could you check if you have this patch installed ?

http://www4.itrc.hp.com/service/patch/patchDetail.do?BC=patch.breadcrumb.main|patch.breadcrumb.search|&patchid=PHCO_29027&context=hpux:800:11:00

Regards,
Robert-Jan

[Robert-Jan Goossens]

By the way.

Have you seen this doc ?

Document description: 11.0 32-bit to 64-bit upgrade
Document id: KBRC00002076

http://www4.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000066733921

[David Lewis_1]

Robert,
Thanks for your help with this:-
Unable to see if patch is loaded as when I run swlist I get error message - hostname unknown returned. Checked swagentd.log and it reports - Failure registering remote procedure call server using protocol sequence ncacn_ip_tcp with endpoint 2121

Also I checked the document you suggested and that is pretty much what I did to convert to 64 bit. However, I still havn't managed to convert yet.

Don't forget that I'm still at single user level
Thx