HPE Community
Operating System - HP-UX
1838105 Members
3786 Online
110124 Solutions
New Discussion

Re: using make_tape_recovery while system in production

 
SOLVED
Go to solution
KEVIN MURRAY
Occasional Contributor

‎05-28-2004 12:11 AM

‎05-28-2004 12:11 AM

using make_tape_recovery while system in production

In the past I have placed my system in single user mode before running "make_tape_recovery -A". Are there any issues with running this boot tape creation while the system is in a full production mode (i.e. multi-user mode)?

This system is running HP-UX 11.11 and Oracle 8.0.6
0 Kudos
Reply
2 REPLIES 2
Shaikh Imran
Honored Contributor

‎05-28-2004 12:16 AM

‎05-28-2004 12:16 AM

Solution

Re: using make_tape_recovery while system in production

Hi,
No there are no issues you can carry on

Regards
I'll sleep when i am dead.
Reply
Patrick Wallek
Honored Contributor

‎05-28-2004 01:06 AM

‎05-28-2004 01:06 AM

Re: using make_tape_recovery while system in production

I have never taken a system down to single-user mode to run an Ignite backup. I really don't see the point in going to single-user mode.

We have our make_tape_recovery's scheduled to run unattended every Saturday morning. Having to go to single-user mode would really be a pain in the a** for 25 machines.

I would recommend that it be run while there is not a whole lot going on with the system, but otherwise you can run it anytime.
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.