VCS 5.0 - cluster problem

[Saravanan_6]

Hi All,

I am getting the following errors while doing the cluster setup for oracle RAC in HP-UX 11.23 box.


Steps did :
---------------
SFRAC installation is done with 2 nodes ( through installsfrac )
SFRAC configuration is done with 2 nodes ( installsfrac -configure )
Fencing is done and rebooted cluster nodes..,

Problem :
-------------
1) gabconfig -a shows two ports are not running ( f-CFS Port and w-Vxconfigd port ).... How to make these two ports are running in both nodes ?
2) "vxdctl -c mode" output is correct in MASTER node but output differs in slave node... How to make both are to be part of cluster ?


Output In Node A
-----------------------

# gabconfig -a
GAB Port Memberships
===============================================================
Port a gen 5afe03 membership 01
Port b gen 5afe05 membership 01
Port d gen 5afe0a membership 01
Port f gen 5afe0e membership ;1
Port f gen 5afe0e visible 0
Port h gen 5afe07 membership 01
Port o gen 5afe08 membership 01
Port v gen 5afe0b membership 01
Port w gen 5afe0c membership ;1
Port w gen 5afe0c visible 0
#

# vxdctl -c mode
mode: enabled: cluster active - MASTER
master: invicta
reconfig: master selection
#


Output In Node B
------------------------

# gabconfig -a
GAB Port Memberships
===============================================================
Port a gen 5afe03 membership 01
Port b gen 5afe05 membership 01
Port d gen 5afe0a membership 01
Port h gen 5afe07 membership 01
Port o gen 5afe08 membership 01
Port v gen 5afe0b membership 01
#

# vxdctl -c mode
mode: enabled: cluster inactive
#

Verified :
-----------
a. vxdctl -k stop and restarted vxconfigd ( CVMVxconfigd) and verified gabconfig -a output
b. Rebooted hosts and ran hastart and verified gabconfig -a output

But CFS port and VXconfigd Port is not running. Please pass me hints on how to make these nodes UP with cluster setup and also reply me back if more information in needed.

Regards
Saravanan

[melvyn burnard]

you may want to go research here:
http://www.symantec.com/enterprise/support/overview.jsp?pid=15066

[Stephen Doud]

The Serviceguard forum does not encompass the Veritas VCS product.
As Melvyn said, check with the Symantec/Veritas website for support.