HPE Community
Operating System - HP-UX
1834480 Members
3818 Online
110067 Solutions
New Discussion

Virtual partitions - console problem

 
SOLVED
Go to solution
Leon van Ofwegen_1
Advisor

‎01-17-2003 06:28 AM

‎01-17-2003 06:28 AM

Virtual partitions - console problem

Hi,

I have one N4000 with 2 proc's, two nic's, two serial ports, 2 vpar's. Is it possible to give each vpar one port? The hardware path's are:

tty 0 0/0/4/0
tty 1 0/0/5/0

I guess it's not possible, because the belong to the same pci bus, but what solution is there then for serial/console access?

Regards,

Leon
0 Kudos
Reply
2 REPLIES 2
Dietmar Konermann
Honored Contributor

‎01-17-2003 06:37 AM

‎01-17-2003 06:37 AM

Solution

Re: Virtual partitions - console problem

Hi, Leon!

That's not possible, but it's not needed either. Your standard console path is grabbed by the vpmon and by pressing ctrl-a you get into the vpmon's menue which allows you to select what partition's console you want to attach to.

Best regards...
Dietmar.
"Logic is the beginning of wisdom; not the end." -- Spock (Star Trek VI: The Undiscovered Country)
Reply
Leon van Ofwegen_1
Advisor

‎01-17-2003 06:41 AM

‎01-17-2003 06:41 AM

Re: Virtual partitions - console problem

Thanks! This just saved a lot of money on serial boards.

Regards,

Leon
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.