vmunix: NOTICE: mod_fs_reg: Cannot retrieve configured loading phase from KRS for module: cifs. Sett

[Tingli]

I just build up a 11.23 system in rp3440 with two local disks only. When systems boots up, it sends out the message "vmunix: NOTICE: mod_fs_reg: Cannot retrieve configured loading phase from KRS for module: cifs. Setting to load at INIT". After it, the messages are:
* The module 'rng' has been loaded.
* The module 'fdd' has been loaded.
* The module 'dmpaa' has been loaded.
* The module 'dmpaaa' has been loaded.
* The module 'dmpap' has been loaded.
* The module 'dmpapg' has been loaded.
* The module 'dmpapf' has been loaded.
* The module 'dmpjbod' has been loaded.
* The module 'dmphpalua' has been loaded.
* The module 'dmphdsalua' has been loaded.
* The module 'ipf' has been loaded.

In the end, the system comes up ok.

[Steven E. Protter]

Shalom,

It's a relatively obscure error message that I can't even google.

I'd say based on the text its a CIFS related issue and you may wish to remove and reinstall CIFS/9000(Samba).

Beyond that I'd run a full set of hardware diagnostics, check the /var/adm/syslog/syslog.log file and consider a response center call on this. They have access to information the peer to peer forum's do not have(not often I will say this).

SEP

[Sameer_Nirmal]

If you have CIFS client version A.02.02 installed, then this is a known issue on 11.23 system. This message is a minor warning message and it does not impact the operation of the HP CIFS Client product in any way.

I would suggest you to contact HP Support to know if there is a fix or when a fixed version is available.

[whiteknight · Accepted solution]

Hi Tingli,

Solution
This message is a minor warning message and it does not impact the
operation of the HP CIFS Client product in any way.

This message is generated by the mod_fs_reg() function and occurs only
on HP-UX 11.23 systems. It will NOT occur on HP-UX 11.11 systems. The
issue is with the new DLKM (Dynamic Loadable Kernel Module) support
added in the A.02.02 release.

At the time of this writing, plans are in place to include a fix in the
next release of the HP CIFS Client that will remove this warning message.

fix

Fixed in CIFS Client version A.02.02.02 or later

please assign points :-)