HPE Community
Operating System - HP-UX
1755628 Members
3855 Online
108836 Solutions
New Discussion юеВ

VPAR failed to boot after Data Migration

 
Shukor
Frequent Advisor

тАО12-04-2009 03:49 AM

тАО12-04-2009 03:49 AM

Re: VPAR failed to boot after Data Migration

accordind to storage team, san switch still maintain, only storage disk migrated. With new storage they maintain the same LUN number eg. LUN # in old storage is 0, LUN # in new storage is 0 as well..
0 Kudos
Torsten.
Acclaimed Contributor

тАО12-04-2009 04:16 AM

тАО12-04-2009 04:16 AM

Re: VPAR failed to boot after Data Migration

You say old path was

0/0/8/0/0.1.58.0.0.0.0

new path is

0/0/8/0/0.62.253.0.0.0.0

So there is a difference and you will get new device files.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Shukor
Frequent Advisor

тАО12-05-2009 09:52 AM

тАО12-05-2009 09:52 AM

Re: VPAR failed to boot after Data Migration

Hi,

Finally the VPAR successfully brought UP with ├в Boot the V-par from the WINSTALL├в solution.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
#vparboot -p vpar1 -I ,/opt/ignite/boot/Rel_B.11.11/WINSTALL

* Completed 100% of archive
* Sat Dec 05 12:21:35 EST 2009: Completed archive load of the source.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Really appreciated u guys efforts, time & solutions.
0 Kudos
Shukor
Frequent Advisor

тАО12-05-2009 09:55 AM

тАО12-05-2009 09:55 AM

Re: VPAR failed to boot after Data Migration

TQ Again..
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.