HPE Community
Operating System - HP-UX
1838469 Members
2977 Online
110126 Solutions
New Discussion

vpar initialising problem

 
Manoj_34
New Member

‎02-11-2005 07:30 AM

‎02-11-2005 07:30 AM

vpar initialising problem

Hello all,
I have recently installed hpux software patch in a vpar.
below is the patch name
Patch_Rel_Dec04 A.1.0 HP Patches for SuperDome-V-Par Rel Dec 2004

after reboot vpar is not initialising properly.
it is continously rebooting.
I am able to halt the vpar and go to single user mode.
i am attaching the rc.log file for error messages.

Thanks in advance

Manoj
0 Kudos
Reply
1 REPLY 1
RAC_1
Honored Contributor

‎02-11-2005 08:16 AM

‎02-11-2005 08:16 AM

Re: vpar initialising problem

There is core dump for vpar initiliaze script. When you boot into single user mode, do file core. Also run STM and check for erros.

Anil
There is no substitute to HARDWORK
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.