web console opportunity

[Greta Blamire]

When I am connecting to my web console from a computer in the same subnet mask as my web console, I have no problems. Otherwise all I get is the, "server down or not responding" message. In the setup book it said for the initial configuration you must be at the same subnet, but I have the initial config completed.
Thanks in advance for your help!

[Bill Hassell · Accepted solution]

You need to specify a subnet mask that matches the new subnet *and* a gateway/router that is on the new subnet. Like any computer, the web console needs 3 values configured (IP, subnet mask and router).

[Greta Blamire]

Hi Bill, thanks for your help! Is there any way to do this without redoing the initial configuration part?

[Lawrence Mahan]

Once you are logged into the HP Secure Web COnsole as an adminitrator you can open the Configuration / Network window and change anything you want for network connections.

[Chandra Venkatraman]

There are some simple programs (HPUX and Windows)
to make these changes without using the GUI in beta
versions. This is very helpful for making changes
(and upgrading) a large number of Secure Web Consoles.
There are also some utilities to 'install' the Secure Web
Consoles without going through the initial screens.

Contact Arula Systems (www.arula.com), A HP-spin off
company based on Secure Web Console if any of these
utilities will be useful for you.

Chandra

[Harish Kumar Sudhamalal]

Hi

When you are moving to a different subnet you need to a add a route to the web console.

You can do so with the route command.

Bye