HPE Community
Operating System - HP-UX
1845033 Members
3403 Online
110233 Solutions
New Discussion

Re: Xvnc configured in Xservers

 
John D'Ausilio
Occasional Advisor

‎08-30-2002 05:59 AM

‎08-30-2002 05:59 AM

Xvnc configured in Xservers

I've successfully run Xvnc by setting up additional servers in /etc/dt/config/Xservers on Solaris. Tries the same on 11.00, and although it works, the graphics look horrible. Anyone tried this and know the correct switches to give to Xvnc to control graphics? The -geometry switch seems to work, but all the text is blocky like the pixel size is too big!
Too much is always better than not enough!
0 Kudos
Reply
2 REPLIES 2
John D'Ausilio
Occasional Advisor

‎08-30-2002 07:29 AM

‎08-30-2002 07:29 AM

Re: Xvnc configured in Xservers

erm .. never mind :)

should have searched a few minutes more before posting .. -fp and the paths to fonts (from another thread) took care of it
Too much is always better than not enough!
0 Kudos
Reply
Alex Glennie
Honored Contributor

‎08-30-2002 07:32 AM

‎08-30-2002 07:32 AM

Re: Xvnc configured in Xservers

I used precompiled binaries from
http://www.csun.edu/~swalton/VNC/

what systems are running what ie vncviewer and vncserver are running where respectively ?

Can you show us a screendump or Xwindows dump -> use xwd(1) of the problem ?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.