HPE Community
Operating System - Linux
1828658 Members
1953 Online
109983 Solutions
New Discussion

How can I specify the XDM-server ip address for remote configuration of Entria X-terminal ?

 
Mads Dyrholm
New Member

‎05-17-2001 02:10 AM

‎05-17-2001 02:10 AM

How can I specify the XDM-server ip address for remote configuration of Entria X-terminal ?

Hi, I have an Entria x-terminal that gets it's configuration from a Linux host via BootP and tftp. Here's the trouble:

Problem: The x-terminal is trying some strange ip-number (that I've never specified) in it's attempt to connect to the XDM server.

Question: How can I specify for the terminal what XDMserver ip-address to go for? maybe some entry in the bootptab file?
0 Kudos
Reply
1 REPLY 1
Nico van Royen
Frequent Advisor

‎05-18-2001 12:14 AM

‎05-18-2001 12:14 AM

Re: How can I specify the XDM-server ip address for remote configuration of Entria X-terminal ?

Wether this works with the Entria terminals I am unsure, but the Envizez series uses the following lines that can try:

File Server List :1.2.3.4, 1.2.3.5
XDMCP Request : Direct
XDMCP Host : 1.2.3.6
XDMCP UDP Port : 177

Hope the entria series uses the same ones .. good luck.

Nico van Royen
If all else fails, try reading the manual...
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.