HPE Community
Operating System - Linux
1754366 Members
5342 Online
108813 Solutions
New Discussion юеВ

HP 4mm DAT

 
SOLVED
Go to solution
Richard Horton
Advisor

тАО08-15-2000 06:42 AM

тАО08-15-2000 06:42 AM

HP 4mm DAT

How do I add my internal SCSI 4mm HP DAT drive to mandrake 7.1. I try using makdev and I get nothing. I see the drive as part of the kernel known hardware at boot up, yet I cannot tar or cpio to the tape drive?

SCO veteran converting to HP UX
0 Kudos
Reply
2 REPLIES 2
Alex Glennie
Honored Contributor

тАО08-15-2000 11:46 AM

тАО08-15-2000 11:46 AM

Solution

Re: HP 4mm DAT

 
Reply
tony j. podrasky
Valued Contributor

тАО09-05-2000 11:41 AM

тАО09-05-2000 11:41 AM

Re: HP 4mm DAT

I'm not familiar with Mandrake.

Take a look in /dev and see if you have the following entries: and . If so,
then just make a soft link to it with rmt0.

ln -s st0 rmt0

and if you have the utility, try doing a and see if it responds.
REMEMBER: Once you eliminate your #1 problem, #2 gets a promotion.
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.