HPE Community
Operating System - Linux
1835214 Members
2347 Online
110078 Solutions
New Discussion

NICs alternation on boot RHEL5

 
SOLVED
Go to solution
Oscar Orlando Erbetta
Occasional Advisor

‎06-05-2009 03:22 PM

‎06-05-2009 03:22 PM

NICs alternation on boot RHEL5

hi all,

i have the following problem,
on a BL480c i've installed RHEL5.2, and have the networking configuration done properly, the problem i have is that everytime i reboot the server, the OS "alternate" the NICs, so eth0 becomes eth2, eth1 becomes eth3; i have to restart several times the server so it alternate again and sets eth0 with the exact mac address of the eth0

help please
0 Kudos
2 REPLIES 2
Ivan Ferreira
Honored Contributor

‎06-06-2009 06:48 AM

‎06-06-2009 06:48 AM

Solution

Re: NICs alternation on boot RHEL5

Please refer to this thread:

http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1123124
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
0 Kudos
Oscar Orlando Erbetta
Occasional Advisor

‎06-06-2009 02:33 PM

‎06-06-2009 02:33 PM

Re: NICs alternation on boot RHEL5

thank you very much!!! i hope this works, otherwise, i'll re-open the thread haha

thanks
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.