Proliant Smart Array scsi internal disk configuration

[Davide Depaoli_3]

Hello,
I'm not a linux expert. I'm working on a following environment:

Linux Red Hat Enterprise 3.0
Proliant DL380
MSA1000 storage array

with boot from san.

Now my customer wants to use the internal server hard disk as a data disk (not a boot disk) but only as filesystem.

Linux see the internal Smart Array controller, but not the hard disk.

Can anyone helps me to do this (if possible) ?

thanks in advance
kind regards
Davide

[Vitaly Karasik_1]

You should start from creating "disks" and partitioning your internal RAID. You can do this or during your DL380 boot in SmartArray BIOS, or using this utility:

HP Array Configuration Utility for Linux
http://h18000.www1.hp.com/support/files/server/us/download/23364.html

Can you send us output of

sfdisk -l

or

fdisk -l /dev/cciss/c0d0

[Davide Depaoli_3]

Hi,
I've created disk in SA Bios and it is seen in ACU, but in Linux I only see the MSA1000 LUNs, and not the internal hdd.

With Hardware Browser I see the Smart Array controller.

[Davide Depaoli_3]

I'm working in a test lab and have started a new Red Hat installation.
With Disk Druid the new disk is available and configurable (/dev/cciss/c0d0p1).

In a already running O.S. is there any command to discover this disk (kudzu doesn't discovered the hdd) ?

thanks Davide

[Alan_152]

Please post here the contents of "fdisk -l". Chances are that you have either not set up an array with the SA64xx, or that the array hasn't been formatted yet with mkfs.

[Davide Depaoli_3]

Unfortunately I'm not more on that lab, and I'm not be able to work on that system.
But my big question is:

if disk-druid see this hdd, in a running linux is there any cmd or GUI utility like disk-druid able to make the hdd available ?

[Alan_152]

If the OS can see the cciss array with fdisk -l, then you will need use fdisk to make a partition (which seems to be done, if you have a p0 assigned to it), then you need to use mkfs to format the partion with an ext3 filesystem, then you need to use "mount" to mount the partition to a mount point.

I would recommend reading chapter 9 of "Unix System Administration Handbook" by Nemeth, et al. A similar chapter is probably somewhere in Nemeth. et al's "Linux System Administration Handbook". Either book is a must for *nix sys admins.