HPE Community
Operating System - Microsoft
1752805 Members
5488 Online
108789 Solutions
New Discussion

Network Configuration Utility 9.7 Removes Port Information when looking at Blades on OA

 
Larry McKain_1
New Member

‎10-07-2009 07:34 AM

‎10-07-2009 07:34 AM

Network Configuration Utility 9.7 Removes Port Information when looking at Blades on OA

We are updating to 8.3 Smartstart and installing the network config utility as part of the install. Prior to this version we were able to see the slot and the port assignments.

Now we are ONLY able to see the Slot number. Am I missing a button to enable this to display. Was it ommitted?

Any help would be greatly appreciated.

Larry
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.