Operating System - Microsoft
1752790
Members
6500
Online
108789
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-19-2001 07:57 AM
тАО01-19-2001 07:57 AM
tracert
I have a setup in my lab where we are testing an application that will send packets from machine to machine using any route that is available, not just the route that is discovered by tracert or used by ping. So, I thought that if I used tracert's -j option I could check to see if a particular pathway was working by specifying one node along the route I want to take. It seems that the -j option allows loose source routing, which I thoguht meant that you would go from your source to your goal, using the specified node(s) and all other nodes were unknown/unspecified. My syntax was:
tracert -j
This didn't work. Is there a way to do this?
tracert -j
This didn't work. Is there a way to do this?
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-19-2001 08:36 AM
тАО01-19-2001 08:36 AM
Re: tracert
The following TechNet article describes the -j option as a way of confirming the return route to a specific node ...
http://support.microsoft.com/support/kb/articles/Q169/2/06.ASP
I don't think it does exactly what you're looking for ...
http://support.microsoft.com/support/kb/articles/Q169/2/06.ASP
I don't think it does exactly what you're looking for ...
"Hope springs eternal."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО06-29-2001 01:25 AM
тАО06-29-2001 01:25 AM
Re: tracert
Hello
What about ping -k ? it is a strict source routing...
By the way. Are you sure that your network-devices (routers) allow source routing ?
HTH
Best Rgds,
Susanna
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP