HPE Community
Operating System - OpenVMS
1829075 Members
2510 Online
109986 Solutions
New Discussion

Re: MDMS Query

 
Shaun Lim
Occasional Contributor

‎02-03-2004 02:05 PM

‎02-03-2004 02:05 PM

MDMS Query

Hi,

I did a tape drive replacement on a tapelibrary ESL9198. After replacement, robot arm was not responding when I issue a move or inventory commands in MDMS.
(e.g. MDMS> move vol GQP253 esl9198_juke/nowait/noassit)

However, load and unload commands in MDMS are working fine.
(e.g. MDMS> load vol GPQ253 /drive=$2$mga1 /nowait)

Thank you.

Shaun Lim
0 Kudos
Reply
2 REPLIES 2
Lokesh_2
Esteemed Contributor

‎02-03-2004 07:40 PM

‎02-03-2004 07:40 PM

Re: MDMS Query

Hi Shaun,

What is the error message you are getting ?

Thanks & regards,
Lokesh
What would you do with your life if you knew you could not fail?
0 Kudos
Reply
Shaun Lim
Occasional Contributor

‎02-03-2004 07:42 PM

‎02-03-2004 07:42 PM

Re: MDMS Query

Hi,

No error message and the robot arm is not moving.

Shaun
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.