SMC Barricade console access

[Mike Smith_33]

Can anyone shed any light on setting up the SMC 7008ABR Broadband Router so that I can connect it and have access to my consoles. I have three of them, one for each ES47 node, connected to the WAN with all the nodes connected to each SMC router. The documentation talks about configuring this for Windows and MacIntosh. I called support but the product is no longer supported. The other support line 877-438-9111 is a paid support line and I am not sure they would even know what to do.

All help is greatly appreciated. Thanks in advance!!

[Volker Halle]

Mike,

the ES47 technical documentation can be found here:

http://h18002.www1.hp.com/alphaserver/es47/es47_tech.html

There is a install/config guide for the Linksys NAT box, which may help you figure out the overall config and may help you configure the Barricade router.

Volker.

[Mike Smith_33]

In searching for this earlier today, I found that one and bookmarked it future reference. This afternoon, I will see if it helps. I will apply points later.

[Volker Halle · Accepted solution]

Mike,

this link looks better:

http://h18026.www1.hp.com/alphaserver/docs/install/WebHelp/common_events/connect_and_set-up_nat_box.htm

It describes setup of the SMC Barricade NAT box, complete with screen-shots and everything !

Volker.

[Mike Smith_33]

This page is exactly what I was looking for. Volker, my hat is off to you. Thanks!!