SNMP Commnad line how to?

[BrianInOxford]

Does anybody know how to do the following to SNMP from a command line?

add a trap for comunity name of "public" and Trap Destination to "155.214.23.105"

and

add a security of "public" / read only with "accept SNMP packets from any host"

[Volker Halle]

Brian,

you didn't tell us your TCP/IP product, so assuming it's HP UCX or TCPIP, try this:

$ UCX SET CONF SNMP /COMMUNITY="public" -
/TYPE=TRAP /ADDRESS=155.214.23.105

$ UCX SET CONF SNMP/COMMUNITY="public" -
/TYPE=READ /ADDRESS=0.0.0.0

To obtain help for these command, use:

$ UCX HELP SET CONF SNMP

You need to re-start the SNMP service for these settings to become active.

Volker.