Operating System - Tru64 Unix
1833403 Members
3005 Online
110052 Solutions
New Discussion

DEGPA-TA on 500au workstation

 
Stephan Teoh
New Member

DEGPA-TA on 500au workstation


I've got a 500au workstation running Tru64 v5.1 with all the latest patchkits, V7.2-1 firmware (newest) and can't get it to run DEGPA-TA at Gigabit.
(Only 100Mbit Full-Duplex which auto-negotiates when OS comes up)

At SRM console, the Gigabit card is not listed. I even tried #lan_config (which only works for settings up to 100Mbit Full Duplex)

I've tried re-seating the NIC, and also forcing the Gigabit switch port to Gigabit which also did not work.

Is there some setting I could use in the /etc/sysconfigtab that will force it to work at Gigabit?

My HP-Compaq 3rd party supplier thinks the 500au might be too old for the card to work.

Any ideas, help is gladly appreciated!

Stephan


3 REPLIES 3
Ralf Puchner
Honored Contributor

Re: DEGPA-TA on 500au workstation

Stephan,

this is not a PC.

Please have a look into the supported option list on the HP web page.

If the card is not detected on SRM it will not work! So select a card supported for 500au (have a look into the support option list of 500au).


Help() { FirstReadManual(urgently); Go_to_it;; }
Mohamed  K Ahmed
Trusted Contributor

Re: DEGPA-TA on 500au workstation

You have o make sure that the card is supported with the system.
Chaeck out these sites:

http://h18000.www1.hp.com/products/quickspecs/soc_archives/80136.html
http://h18002.www1.hp.com/alphaserver/workstations/retired/auseries/

HTH

Mohamed
Stephan Teoh
New Member

Re: DEGPA-TA on 500au workstation

Thanks to Ralph and Mohammed for their replies. I've basically have no hope of
Gigabit on 500au unless it's Fibre.