HPE Community
Operating System - Tru64 Unix
1829749 Members
2154 Online
109992 Solutions
New Discussion

Re: gs1280 Tru64 5.12 SYSMAN NOT SAVING SETTINGS

 
ABM Support Team
Occasional Contributor

‎03-12-2009 08:13 PM

‎03-12-2009 08:13 PM

gs1280 Tru64 5.12 SYSMAN NOT SAVING SETTINGS

we have setup the network settings and ip addresses using sysman and system works fine but when gs1280 is rebooted you have to set them all up again. is there a way to save them so on rebbot they are retained.
0 Kudos
2 REPLIES 2
Steven Schweda
Honored Contributor

‎03-12-2009 09:14 PM

‎03-12-2009 09:14 PM

Re: gs1280 Tru64 5.12 SYSMAN NOT SAVING SETTINGS

I assume that they should be retained, but I
can't get to my Tru64 systems at the moment.
(I certainly don't have this problem on my
Tru64 systems.)

In general, for a Tru64 question, you can
expect to get better answers sooner in a
Tru64 forum than in this HP-UX forum.
0 Kudos
Rob Leadbeater
Honored Contributor

‎03-12-2009 09:49 PM

‎03-12-2009 09:49 PM

Re: gs1280 Tru64 5.12 SYSMAN NOT SAVING SETTINGS

Hi,

If the network settings were entered using sysman then they should be saved.

After you've run sysman, check /etc/rc.config and make sure that the IP addresses are in there as you would expect.

Cheers,

Rob
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.