HPE Community
Operating System - Tru64 Unix
1840212 Members
3066 Online
110162 Solutions
New Discussion

Re: KZPCC set reconfiguring from RAID0 to RAID1

 
k1sa
Occasional Advisor

‎01-09-2007 08:31 PM

‎01-09-2007 08:31 PM

KZPCC set reconfiguring from RAID0 to RAID1

Hi!
I have KZPCC controller with RAID0 set (2 hard drives), with Tru64 Unix v5.1b installed (DS25 AlphaServer). Can I reconfigure RAID0 (Stripe) to RAID1 (Mirror), without Unix reinstalling? Space usage on this set is ~15%.

Juris
0 Kudos
3 REPLIES 3
Hein van den Heuvel
Honored Contributor

‎01-09-2007 10:51 PM

‎01-09-2007 10:51 PM

Re: KZPCC set reconfiguring from RAID0 to RAID1

Sorry, no. Theoretically it is possible, but the swxcr does not have those smarts. You'll have to make a full backup. Delete the raid-0 drive and use the physical drives to in the group to create a the raid-1 set.
Specially with just 15 % used, which will go to 30% of course, I would feel much more comfortable with raid-1 and it might give a little more (read) speed.

Hein.
0 Kudos
k1sa
Occasional Advisor

‎01-09-2007 11:42 PM

‎01-09-2007 11:42 PM

Re: KZPCC set reconfiguring from RAID0 to RAID1

Thank's

Juris
0 Kudos
k1sa
Occasional Advisor

‎01-09-2007 11:44 PM

‎01-09-2007 11:44 PM

Re: KZPCC set reconfiguring from RAID0 to RAID1

Thank you!

Juris
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.