HPE Community
Operating System - Tru64 Unix
1840148 Members
4107 Online
110161 Solutions
New Discussion

ra200 disk failure does not show up on storage works command console

 
Michael Schulte zur Sur
Honored Contributor

‎11-04-2003 02:34 AM

‎11-04-2003 02:34 AM

ra200 disk failure does not show up on storage works command console

Hi,

I have had a disk failure in a raid 1 ra200 raidset. If it were not for the old swxcrmon, I would not have noticed, because the storage works command console v2.2.0.213 did not show it on host icon level. The ra200 applet version is v2.1-316. The system is running v4.0f. Any idea?

greetings

Michael
0 Kudos
3 REPLIES 3
Ninad_1
Honored Contributor

‎11-04-2003 02:40 PM

‎11-04-2003 02:40 PM

Re: ra200 disk failure does not show up on storage works command console

Hi Michael,
I dont have any answer to your question but why dont you post your message in Storage - SAN category ? May be you will get a reply

Ninad
0 Kudos
Ralf Puchner
Honored Contributor

‎11-04-2003 06:54 PM

‎11-04-2003 06:54 PM

Re: ra200 disk failure does not show up on storage works command console

Or open a call within the support center?
Help() { FirstReadManual(urgently); Go_to_it;; }
0 Kudos
Michael Schulte zur Sur
Honored Contributor

‎11-04-2003 07:18 PM

‎11-04-2003 07:18 PM

Re: ra200 disk failure does not show up on storage works command console

Hi Ninad, hi Ralf,

your suggestions are good, I will do them.

thanks,

Michael
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.