- Community Home
- >
- Storage
- >
- Legacy
- >
- Optical Jukeboxes and Drives
- >
- Re-setting Simple Trax
Categories
Company
Local Language
Forums
Discussions
Knowledge Base
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-15-2001 10:18 PM - last edited on 02-24-2014 07:06 PM by Lisa198503
09-15-2001 10:18 PM - last edited on 02-24-2014 07:06 PM by Lisa198503
Re-setting Simple Trax
I use Simple Trax for weekly back-up. I've accumulated a years worth of disks since each backup only adds new or changed information. Thus, my first disk has some important basic data that has not changed, the last disk only has recent data, and the disks in between have some good data and a lot of junk I don't need. I want to start over so a fresh disk will back up ALL my current data and build from there. How do I "start over"?
P.S. This thread has been moved from Disk to Optical Jukeboxes & Drives. -HP Forum Moderator