LinuxPE Boot not working

[Ian_172]

Hi,
I've recently upgraded our RDP server from version 2.x to 3.10. All my existing RDP jobs work and the new 32bit and 64bit windows installs using the WinPE boot enviroment.

However when I try to run any of the jobs that uses the Linux PE boot enviroment they all fail.

The servers boot, obtain an IP address from the DHCP server, then the linuxPE boot starts, it uncompresses Linux (ok), boots the kernal, Configures eth0(DHCP), Configures eth1 (DHCP) then Retries Eth0\eth1. Then it reports that it cannot detect a link, that no network is reachable and it has failed to find the express mount.

I've been through the LinuxPE configuration and set all the parameters so that it is looking in the right place for the express share etc.

Any suggestions????

Thanks very much in advance,

Cheers Ian